Bilatu
22-tik 1-10 emaitza erakusten
Stability analysis under thermogravitational effect
(Elsevier Masson SAS, 2020)
In the present work, an interferometric unsteady analysis of the thermogravitational technique was for the first time attempted in a paralelepipedic microcolumn
using binary mixtures with negative Soret coefficients. In ...
Thermophoresis as a technique for separation of nanoparticle species in microfluidic devices
(Elsevier Masson SAS, 2020)
This paper presents numerical studies of thermophoresis approach for separation of nanoparticles in liquid media. We simulated the thermophoresis process to test it as a method of separation of particles in suspension. At ...
Aspects Concerning the Fabrication of Magnetorheological Fluids Containing High Magnetization FeCo Nanoparticles
(MDPI, 2021)
Recently, our collaborative work in the fabrication of a magnetorheological fluid (MRF) containing high magnetization FeCo nanoparticles (NPs, fabricated in our laboratories using the chemical reduction technique; MS = 212 ...
Numerical analysis of different mass transfer models for falling film absorbers
(Elsevier Ltd., 2022)
Different methodologies have been used in the literature to determine the absorbed vapour mass flux in falling film absorbers. So far, however, there has been little discussion about the impact of different ap- proaches ...
Design of a Radiant Heat Capturing Device for Steel Mills
(International Centre for Sustainable Development of Energy, Water and Environment Systems, 2021)
This paper approaches the energy transition towards decarbonization and lower primary energy use in the steel and glass industries through the exploitation of radiant waste heat. In contrast with exhaust gases heat recovery, ...
Steady-state Measurements of Ternary Mixtures in Thermogravitational Microcolumn Using Optical Digital Interferometry
(Springer Nature B.V., 2021)
Steady-state measurements in a thermogravitational microcolumn using optical digital interferometry are presented here for the first time in the literature in the case of ternary mixtures. These measurements enabled the ...
Design and 3D printing of an electrochemical sensor for Listeria monocytogenes detection based on loop mediated isothermal amplification
(Elsevier, 2023)
The aim of this work is the design and 3D printing of a new electrochemical sensor for the detection of Listeria monocytogenes based on loop mediated isothermal amplification (LAMP). The food related diseases involve a ...
High magnetization FeCo nanoparticles for magnetorheological fluids with enhanced response
(Royal Society of Chemistry, 2021)
We present results concerning the fabrication of a new magnetorheological fluid with FeCo magnetic nanoparticles (NPs) as magnetic fillers. These NPs have been fabricated by using the chemical reduction technique and show ...
Influence of the test-chamber shape on the performance of conductometric gas sensors
(Elsevier, 2022)
In this article, CFD simulations results are presented as a key tool to the comprehension of the target gas concentration evolution in a test chamber, at different working conditions. The simulation results are compared ...
Analysis of thermophoresis for separation of polystyrene microparticles in microfluidic devices
(Elsevier, 2022)
We analysed the thermodiffusion phenomenon both numerically and experimentally for size-based separation of polystyrene microparticles. For model validation, we followed previously published numerical studies using ANSYS ...