Bilatu
42-tik 1-20 emaitza erakusten
Análisis Numérico del Efecto de la Termoforesis para la Separación de Diferentes Poblaciones de Exosomas
(Servicio Editorial de la Universidad del País Vasco, 2017)
Los sistemas microfluídicos han demostrado ser una alternativa prometedora ante procesos convencionales de separación y caracterización. Este trabajo muestra el estudio numérico del fenómeno de la termoforesis en un ...
Fluido magnetikoen portaera magneto-reologiko eta biskoelastikoa
(Mondragon Unibertsitateko Zerbitzu Editoriala, 2012)
Fluido magnetikoak likido eramaile eta partikula magnetikoez daude osatuta, eta beraien portaera aplikatutako eremu magnetikoaren menpekoa da. Lan honetan, olio mineralez, sufaktante batez, likatzaile batez eta partikula ...
Thermodiffusion in multicomponent n-alkane mixtures
(Nature Research (Part of Springer Nature), 2017)
Compositional grading within a mixture has a strong impact on the evaluation of the pre-exploitation distribution of hydrocarbons in underground layers and sediments. Thermodiffusion, which leads to a partial diffusive ...
Microfluidic separation processes using the thermodiffusion effect
(Elsevier B.V., 2018)
The numerical and experimental results presented in this work show that a relatively small temperature gradient
(5K), has great potential to generate a separation in interesting mixtures for biological purpose. In fact, ...
Radiant waste heat recovery from steelmaking and glass industry
(Edp Sciences, 2019)
This paper tackles the problem of industrial waste heat recovery through an unexploited heat transfer mechanism: thermal radiation. Energy intensive industries have a considerable potential of unused radiant heat, which ...
Adaptive coatings based on polyaniline for direct 2D observation of diffusion processes in microfluidic systems
(Elsevier, 2016)
Microfluidic devices are poised to dramatically influence the future of the process industry. Therefore the understanding and proper evaluation of the flow and mixing behaviour at microscale becomes a very important issue. ...
Contact angle measurement for LiBr aqueous solutions on different surface materials used in absorption systems
(Elsevier Ltd., 2018)
Wetting surface is a very important issue for the design of absorption applications and heat exchangers. The contact angle is deemed essential in wettability studies; However, LiBr aqueous solution contact angle studies ...
Determination of the molecular diffusion coefficients in ternary mixtures by the sliding symmetric tubes technique
(AIP Publishing, 2014)
A new analytical methodology has been developed to determine the diagonal and cross-diagonal molecular diffusion coefficients in ternary mixtures by the Sliding Symmetric Tubes technique. The analytical solution is tested ...
Stability analysis under thermogravitational effect
(Elsevier Masson SAS, 2020)
In the present work, an interferometric unsteady analysis of the thermogravitational technique was for the first time attempted in a paralelepipedic microcolumn
using binary mixtures with negative Soret coefficients. In ...
Thermophoresis as a technique for separation of nanoparticle species in microfluidic devices
(Elsevier Masson SAS, 2020)
This paper presents numerical studies of thermophoresis approach for separation of nanoparticles in liquid media. We simulated the thermophoresis process to test it as a method of separation of particles in suspension. At ...
Aspects Concerning the Fabrication of Magnetorheological Fluids Containing High Magnetization FeCo Nanoparticles
(MDPI, 2021)
Recently, our collaborative work in the fabrication of a magnetorheological fluid (MRF) containing high magnetization FeCo nanoparticles (NPs, fabricated in our laboratories using the chemical reduction technique; MS = 212 ...
Numerical analysis of different mass transfer models for falling film absorbers
(Elsevier Ltd., 2022)
Different methodologies have been used in the literature to determine the absorbed vapour mass flux in falling film absorbers. So far, however, there has been little discussion about the impact of different ap- proaches ...
Design of a Radiant Heat Capturing Device for Steel Mills
(International Centre for Sustainable Development of Energy, Water and Environment Systems, 2021)
This paper approaches the energy transition towards decarbonization and lower primary energy use in the steel and glass industries through the exploitation of radiant waste heat. In contrast with exhaust gases heat recovery, ...
Steady-state Measurements of Ternary Mixtures in Thermogravitational Microcolumn Using Optical Digital Interferometry
(Springer Nature B.V., 2021)
Steady-state measurements in a thermogravitational microcolumn using optical digital interferometry are presented here for the first time in the literature in the case of ternary mixtures. These measurements enabled the ...
Thermodiffusion in Ternary Mixtures of Water/Ethanol/Triethylene Glycol: First Report on the DCMIX3-Experiments Performed on the International Space Station
(Springer, 2018)
We report on thermodiffusion experiments conducted on the International Space Station ISS during fall 2016. These experiments are part of the DCMIX (Diffusion and thermodiffusion Coefficients Measurements in ternary Mixtures) ...
Sorption isotherm, glass transition, and diffusion coefficient of polyacrylamide/water solutions
(ACS Publications, 2012)
The sorption isotherm, the glass transition, and the mutual diffusion coefficient of polyacrylamide/water solutions are obtained experimentally. All of these parameters are measured in the concentrated regime by gravimetric ...
Determination of molecular diffusion coefficient in n-Alkane binary mixtures: empirical correlations
(ACS Publishing, 2012)
In this work we have measured the molecular diffusion coefficient of the n-alkane binary series nCi-nC6, nCi-nC10, and nCi-nC12 at 298 K and 1 atm and a mass fraction of 0.5 by using the so-called sliding symmetric tubes ...
Design and 3D printing of an electrochemical sensor for Listeria monocytogenes detection based on loop mediated isothermal amplification
(Elsevier, 2023)
The aim of this work is the design and 3D printing of a new electrochemical sensor for the detection of Listeria monocytogenes based on loop mediated isothermal amplification (LAMP). The food related diseases involve a ...
High magnetization FeCo nanoparticles for magnetorheological fluids with enhanced response
(Royal Society of Chemistry, 2021)
We present results concerning the fabrication of a new magnetorheological fluid with FeCo magnetic nanoparticles (NPs) as magnetic fillers. These NPs have been fabricated by using the chemical reduction technique and show ...
Influence of the test-chamber shape on the performance of conductometric gas sensors
(Elsevier, 2022)
In this article, CFD simulations results are presented as a key tool to the comprehension of the target gas concentration evolution in a test chamber, at different working conditions. The simulation results are compared ...