Search
Now showing items 471-480 of 758
Effect of surface integrity generated by machining on isothermal low cycle fatigue performance of Inconel 718
(Elsevier Ltd., 2022)
Critical aero-engine components such as turbine discs must withstand severe cyclic stresses, which can eventually lead to low cycle fatigue (LCF) failures. These components are made of difficult-to-cut alloys and machining ...
Simple voltage balancing method to protect series-connected devices experimentally verified in a 5L-MPC converter
(IEEE, 2018)
This paper presents a solution for the voltage balance problem of the series-connected devices that can be applied to multilevel converters in which the series-connected devices need to block twice their switched voltage. ...
A Performance Study of a Horizontal-axis Micro-turbine in a Numerical Wave Flume
(Elsevier Ltd., 2017)
Numerical studies of performance of a 3-bladed Savonius type horizontal-axis wave energy converter are presented. Numerical simulations based on a volume of fluid (VOF) method coupled with a finite volume method (FVM) ...
Hardening prediction of diverse materials using the Digital Image Correlation technique
(Elsevier, 2018)
In recent years, due to the introduction of higher resistance materials in the automotive sector, sheet metal-forming tool-makers have been forced to deal with more challenging process designs. Therefore, the optimisation ...
DC-Link Neutral Point Control for 3L-NPC Converters Utilizing Selective Harmonic Elimination PWM
(IEEE, 2021)
Selective harmonic elimination–pulsewidth modulation (SHE–PWM) is a modulation technique widely used to improve the efficiency and harmonic content in medium-voltage high-power converters. Among these converters, the ...
Fe nanoparticles produced by electric explosion of wire for new generation of magneto-rheological fluids
(IOP Publishing, 2018)
Iron magnetic nanoparticles were produced by the technique of the electric explosion of a wire (EEW). The major crystalline phase (95 ± 1%) was α-Fe with lattice parameter a = 0.2863(3) nm. The size of the coherent diffraction ...
Diferencia en las percepciones sobre las prácticas de gestión de personas entre mano de obra directa e indirecta. Estudio de caso de una cooperativa de MONDRAGON
(Universidad Complutense de Madrid, 2022)
El principal objetivo de la presente investigación es analizar, basándose en la teoría AMO, las diferencias en las percepciones de las personas trabajadoras de mano de obra directa e indirecta con respecto a las prácticas ...
Surface roughness assessment on hole drilled through the identification and clustering of relevant external and internal signal statistical features
(Elsevier, 2022)
Drilling is a continuous cutting process where two or more cutting edges remove the material, to obtain the desired feature. During the chip evacuation, it generally rubs against the generated surface. Thus, the roughness ...
Study of alternatives and experimental validation for predictions of hole-edge fatigue crack growth in 42CrMo4 steel
(Elsevier, 2018)
The objective of this work is to establish pertinent criteria allowing an optimal alternative to be chosen for calculating the inputs needed to make Run/Repair/Replace decisions and to program inspection plans for cracked ...
Robustness of inventory replenishment and customer selection policies for the dynamic and stochastic inventory-routing problemRobustness of inventory replenishment policies and client selection methods for the stochastic and dynamic inventory-routing problem
(Elsevier, 2016)
When inventory management, distribution and routing decisions are determined simultaneously, implementing a vendor-managed inventory strategy, a difficult combinatorial optimization problem must be solved to determine which ...