Bilatu
74-tik 61-70 emaitza erakusten
Exploring the effectiveness of using internal CNC system signals for chatter detection in milling process
(Elsevier, 2023)
Chatter is a harmful self-excited vibration that commonly occurs during milling processes. Data-driven chatter detection and prediction is critical to achieve high surface quality and process efficiency. Most existing ...
A tribological characterisation of Ti-48Al-2Cr-2Nb and Ti-6Al-4V alloys with dry, flood, and MQL lubricants
(Elsevier, 2023)
The development of cutting tools requires the knowledge of tribological phenomena at the tool – workpiece contact area. This knowledge is in dearth particularly for difficult-to-cut alloys like gamma titanium aluminide ...
Effect of Tool Geometry and LCO2 Cooling on Cutting Forces and Delamination when Drilling CFRP Composites Using PCD Tools
(Elsevier, 2022)
Lightweight materials like Carbon Fiber Reinforced Polymers (CFRPs) present certain challenges, mainly regarding the resultant surface integrity of the holes. Different techniques such as optimized tool geometries, machining ...
Influence of Coulomb’s Friction Coefficient in Finite Element Modeling of Orthogonal Cutting of Ti6Al4V
(Trans Tech Publications, 2022)
The reliability of the pertinent parameters set of Johnson-Cook constitutive model is highly linked with the friction condition at the tool-chip-workpiece interface. In the present work, a study on the influence of Coulomb’s ...
Influence of cryogenic grinding surface on fatigue performance of carburised 27MnCr5
(Elsevier, 2023)
Automotive transmission components are subjected to cyclic loads and, thus, must have a reliable fatigue performance. Since fatigue cracks nucleate at the surface, it is necessary to guarantee that its surface integrity ...
Mechanical properties of friction induced nanocrystalline pearlitic steel
(Springer Nature, 2022)
Nanocrystalline structured variants of commercially available alloys have shown potential for boosting the mechanical properties of these materials, leading to a reduction in waste and thereby retaining feasible supply ...
Mechanical Properties and Fatigue Performance of 17-4 PH Stainless Steel Manufactured by Atomic Diffusion Additive Manufacturing Technology
(MDPI, 2023)
Additive Manufacturing (AM) is gaining importance as an alternative and complementary technology to conventional manufacturing processes. Among AM technologies, the Atomic Diffusion Additive Manufacturing (ADAM) technology ...
Hole quality improvement in CFRP/Ti6Al4V stacks using optimised flow rates for LCO2 and MQL sustainable cooling/lubrication
(Elsevier, 2024)
Carbon fibre reinforced polymer/titanium stacks (CFRP/Ti6Al4V) are employed in aeronautics due to their excellent weight-to-strength ratio and corrosion properties. However, these same material properties present challenges ...
Correcting distortions of thin-walled machined parts by machine hammer peening
(Elsevier, 2023)
Thin-walled aerostructural components frequently get distorted after the machining process. Reworking to correct distortions or eventually rejecting parts significantly increases the cost. This paper proposes a new approach ...
Combining experimental and FEM approaches to determine the influence of workpiece temperature on fundamental variables in the machining process
(Materials Research Forum LLC, 2024)
In machining it is common practice to use lubricants to enhance machinability, resulting in improved part quality and reduced tool wear. However, emerging efforts are centered on mitigating the environmental impact of ...