Grinding is a machining process specially indicated for finishing operations in hard materials, in order to obtain low surface roughness (Ra 0.1 μm to 2μm) and tight tolerances. The cutting tool is the grinding wheel which ...

The last decades, the electromechanical control systems are being replaced by Programmable Electronic Control Systems. The challenge is that these new systems have to be at least as safe as the replaced ones. Any company ...

DC energy solutions are gaining interest in recent years, due to improvements in power electronics. Some companies have developed solutions for the domestic implementation of DC power systems. This article analyzes the ...

In this paper a thermal test procedure and a calibration method for lumped parameter models are presented. Analytical models provide fast thermal simulations in comparison with finite element methods (FEM) and computed ...

Temperature is a determinant parameter in terms of performance, lifespan and safety working with li-ion batteries. Working above 45°C, in hot climates, has direct influence in the cycle life of the battery and can cause a ...

The reduced capability of the 5L-NPC Inverter to balance the voltages of the four DC-bus capacitors makes this converter unattractive for real power applications. This is especially true if the load demands active power. ...