Different methodologies have been used in the literature to determine the absorbed vapour mass flux in falling film absorbers. So far, however, there has been little discussion about the impact of different ap- proaches ...

This dissertation presents the experimental and numerical dynamic analysis of press-formed viscoelastic sandwich structures composed by two thin metallic face layers and a constrained viscoelastic film. Such structures can ...

A twofold analysis is performed on an experimental set-up comprising a low-Reynolds wind tunnel, with the aim of quantifying the effect of measurand uncertainties and operative condition variations in the lift and drag ...

An application-agnostic procedure is outlined for checking the validity of momentum-deficit-based drag measurements performed under different turbulent conditions in a wind tunnel. The approach defines a two-step methodology: ...

Butterfly valves are widely used industrial piping components as on-off and flow controlling devices. The main challenge in the design process of this type of valves is the correct dimensioning to ensure ...

Wetting surface is a very important issue for the design of absorption applications and heat exchangers. The contact angle is deemed essential in wettability studies; However, LiBr aqueous solution contact angle studies ...

In this paper a novel numerical methodology for calculating non-uniform residual stress distributions during the glass tempering process is presented. Tempering techniques lead to non-uniform heat transfer rates causing ...