Bilatu
49-tik 21-30 emaitza erakusten
Sensitivity analysis of the input parameters of a physical based ductile failure model of Ti-6Al-4V for the prediction of surface integrity
(Elsevier Ltd, 2020)
In machining of Ti-6Al-4V, it is commonly reported the appearance of segmented chip produced by adiabatic shearing (at high cutting speeds) and lack of ductility (at low cutting speeds). Moreover, machining is a manufacturing ...
Influence of lubrication condition on the surface integrity induced during drag finishing
(Elsevier Ltd, 2020)
Tribofinishing is one of the most popular polishing process in industry. The action of small abrasive media around parts enables to reduce significantly surface roughness and at the same time, to induce compressive residual ...
Surface drag analysis after Ti-6Al-4V orthogonal cutting using grid distortion
(Elsevier Ltd, 2020)
Surface integrity directly affects the mechanical behavior of the workpiece, which is especially relevant on fatigue behavior. To characterize the quality of the machined surface, aspects such as material damage, roughness ...
Prediction of Surface Roughness of SLM Built Parts after Finishing Processes Using an Artificial Neural Network
(MDPI, 2022)
A known problem of additive manufactured parts is their poor surface quality, which influences product performance. There are different surface treatments to improve surface quality: blasting is commonly employed to improve ...
Influence of cryogenic grinding surface on fatigue performance of carburised 27MnCr5
(Elsevier, 2023)
Automotive transmission components are subjected to cyclic loads and, thus, must have a reliable fatigue performance. Since fatigue cracks nucleate at the surface, it is necessary to guarantee that its surface integrity ...
Improving surface integrity when drilling CFRPs and Ti-6Al-4V using sustainable lubricated liquid carbon dioxide
(Elsevier, 2022)
In the quest for decreasing fuel consumption and resulting gas emissions in the aeronautic sector, lightweight materials such as Carbon Fiber Reinforced Polymers (CFRPs) and Ti-6Al-4V alloys are being used. These materials, ...
Influence of Coulomb’s Friction Coefficient in Finite Element Modeling of Orthogonal Cutting of Ti6Al4V
(Trans Tech Publications, 2022)
The reliability of the pertinent parameters set of Johnson-Cook constitutive model is highly linked with the friction condition at the tool-chip-workpiece interface. In the present work, a study on the influence of Coulomb’s ...
A novel indirect cryogenic cooling system for improving surface finish and reducing cutting forces when turning ASTM F-1537 cobalt-chromium alloys
(Springer, 2020)
This paper presents a novel indirect cryogenic cooling system, employing liquid nitrogen (LN2) as a coolant for machining the difficult-to-cut ASTM F-1537 cobalt-chromium (CoCr) alloy. The prototype differs from the already ...
Adiabatic self-heating determination for Ti6Al4V at different temperatures
(Elsevier, 2023)
Nowadays, numerical models are one of the most widely used techniques to predict material performance subjected to different manufacturing processes. However, to obtain accurate predictions, these models require reliable ...
Mechanical properties of friction induced nanocrystalline pearlitic steel
(Springer Nature, 2022)
Nanocrystalline structured variants of commercially available alloys have shown potential for boosting the mechanical properties of these materials, leading to a reduction in waste and thereby retaining feasible supply ...