Bilatu
3045-tik 2961-2970 emaitza erakusten
Uncertainty of Temperature Measurements in Dry Orthogonal Cutting of Titanium Alloys
(Elsevier, 2015)
Infrared radiation thermometer is used to measure the temperature of tool during dry orthogonal cutting of titanium alloys. The accuracy of measured temperature depends on several parameters such as the experimental set-up, ...
Reuse in Safety Critical Systems: Educational Use Case Final Results
(IEEE, 2015)
The University of Mondragon, has participated in an European ARTEMIS project called SafeCer during 4 years. The main objective of the project has been to research about the "Reuse of safety related embedded systems and ...
Reuse in safety critical systems : educational use case first experiences
(IEEE, 2014)
In order to maintain Europe as world leader in development of safety relevant systems one of the keys would be to join together the European industrial, academic and scientific communities. One of the main industrial ...
Reuse in safety critical systems: educational use case
(IEEE, 2013)
The last decades, the electromechanical control systems are being replaced by Programmable Electronic Control Systems. The challenge is that these new systems have to be at least as safe as the replaced ones. Any company ...
A performance-based taxonomy of entrepreneurial universities
(InderScience, 2018)
The European higher education landscape has experienced dramatic changes in the last decades and the entrepreneurial university has turned into a potential solution to these perceived problems. Therefore, this paper proposes ...
Evaluation of different flow stress laws coupled with a physical based ductile failure criterion for the modelling of the chip formation process of Ti-6Al-4V under broaching conditions
(Elsevier, 2019)
During the machining of Ti-6Al-4V the changing deformation mechanisms produce a complex microstructure of segmented chips, which directly influenced tool-wear and process stability. Numerical simulation could give an insight ...
Determination of molecular diffusion coefficient in n-Alkane binary mixtures: empirical correlations
(ACS Publishing, 2012)
In this work we have measured the molecular diffusion coefficient of the n-alkane binary series nCi-nC6, nCi-nC10, and nCi-nC12 at 298 K and 1 atm and a mass fraction of 0.5 by using the so-called sliding symmetric tubes ...
The district energy-efficient retrofitting of Torrelago (Laguna de Duero - Spain)
(IOP Publishing, 2019)
The urban growth is estimated to reach up the 66 % by 2050 and consequently the need of resources within the cities will increase significantly. This, combined with the 40 % of energy consumption and 36 % of CO2 emissions ...
Tool Damage and Adhesion Effects in Turning and Drilling of Hardened Steels
(World Academy of Science, 2016)
Noteworthy results have been obtained in the turning and drilling of hardened high-strength steels using tungsten carbide based cutting tools. In a finish turning process, it was seen that surface roughness and tool flank ...
Higher harmonics compensation in grid-connected PWM converters for renewable energy interface and active filtering
(Przegląd Elektrotechniczny, 2011)
The paper presents overview of high-order harmonics compensation methods applied for control of grid-connected converter. Two harmonic compensation methods are presented. One based on band-pass filers cooperating with ...