Bilatu
15-tik 11-15 emaitza erakusten
Effect of Tool Geometry and LCO2 Cooling on Cutting Forces and Delamination when Drilling CFRP Composites Using PCD Tools
(Elsevier, 2022)
Lightweight materials like Carbon Fiber Reinforced Polymers (CFRPs) present certain challenges, mainly regarding the resultant surface integrity of the holes. Different techniques such as optimized tool geometries, machining ...
Influence of Coulomb’s Friction Coefficient in Finite Element Modeling of Orthogonal Cutting of Ti6Al4V
(Trans Tech Publications, 2022)
The reliability of the pertinent parameters set of Johnson-Cook constitutive model is highly linked with the friction condition at the tool-chip-workpiece interface. In the present work, a study on the influence of Coulomb’s ...
Hole quality analysis of AISI 304-GFRP stacks using robotic drilling
(Elsevier B.V., 2022)
Although drilling of FRP - metal stacks is the most widely used machining operation for these materials, it remains challenging in many aspects (tool wear, vibrations, delamination, poor surface finish, etc). In this ...
Numerical modelling of the drag finishing process at a macroscopic scale to optimize surface roughness improvement on additively manufactured (SLM) Inconel 718 parts
(Elsevier B.V., 2022)
Drag finishing is one of the mass finishing processes that enhances surface roughness on complex and rough parts produced by additive manufacturing. This paper proposes a model to simulate abrasive media flowing around the ...
Mechanical properties of friction induced nanocrystalline pearlitic steel
(Springer Nature, 2022)
Nanocrystalline structured variants of commercially available alloys have shown potential for boosting the mechanical properties of these materials, leading to a reduction in waste and thereby retaining feasible supply ...