Buscar
Mostrando ítems 3171-3180 de 3272
La evaluación de la ejecución de tareas por parte de los usuarios en interfaces industriales mediante el cuestionario USEUser evaluation of task execution at industrial interfaces using the USE questionnaire
(AEIPRO, 2019)
Information and Communication Technologies (ICTs) are widely used in organizations and their use has many favourable consequences, fostering interaction and collaboration, workplace learning, job performance and productivity. ...
Hybrid ac/dc microgrids. Part II : Review and classification of control strategies
(Elsevier, 2015)
Microgrids are envisioned as one of the most suitable alternatives for the integration of distributed generation units in the utility grid, as they efficiently combine generation, energy storage and loads in the same ...
Sensitivity analysis of the input parameters of a physical based ductile failure model of Ti-6Al-4V for the prediction of surface integrity
(Elsevier Ltd, 2020)
In machining of Ti-6Al-4V, it is commonly reported the appearance of segmented chip produced by adiabatic shearing (at high cutting speeds) and lack of ductility (at low cutting speeds). Moreover, machining is a manufacturing ...
Influence of lubrication condition on the surface integrity induced during drag finishing
(Elsevier Ltd, 2020)
Tribofinishing is one of the most popular polishing process in industry. The action of small abrasive media around parts enables to reduce significantly surface roughness and at the same time, to induce compressive residual ...
Procedure to predict residual stress pattern in spray transfer multipass welding
(Springer, 2015)
Gas metal arc welding (GMAW) is one of the most used joining method in the industry. However, one of the main problems of this process is the generation of residual stresses which have direct impact on the fatigue life of ...
Digital Interferometry Applied to Thermogravitational Technique
(Springer, 2018)
In this work, we have applied Optical Digital Interferometry approach to thermogravitational micro-column technique. By the new analysis, we examine the entire height of the micro-column and determine the complete concentration ...
Thermodiffusion Coefficients of Water/Ethanol Mixtures for Low Water Mass Fractions
(Springer, 2016)
The difficulty of measuring the thermodiffusion coefficients by optical properties of water-ethanol binary mixtures of approximately 20 wt % of water has been highlighted by several authors in recent years. This is because ...
A Note on Interpreting Tool Temperature Measurements from Thermography
(Taylor & Francis, 2015)
Thermography (thermal imaging) is a well-established experimental method for studying cutting tool temperature distributions. In one form, cutting edge temperatures within the chip / tool contact area are deduced from ...
A performance-based taxonomy of entrepreneurial universities
(InderScience, 2018)
The European higher education landscape has experienced dramatic changes in the last decades and the entrepreneurial university has turned into a potential solution to these perceived problems. Therefore, this paper proposes ...
Medium voltage-high power converter topologies comparison procedure for a 6.6kV Drive Application using 4.5kV IGBT Modules
(IEEE, 2012)
This paper presents a general comparison procedure for medium voltage - high power multilevel converter topologies and semiconductors, which is mainly based on analyzing the performance limits of the converters output ...