Buscar
Mostrando ítems 1-10 de 13
Effect of surface integrity generated by machining on isothermal low cycle fatigue performance of Inconel 718
(Elsevier Ltd., 2022)
Critical aero-engine components such as turbine discs must withstand severe cyclic stresses, which can eventually lead to low cycle fatigue (LCF) failures. These components are made of difficult-to-cut alloys and machining ...
Influence of tool wear on residual stresses when turning Inconel 718
(Elsevier, 2016)
This paper analyzes the effect of tool wear on residual stresses when turning. Inconel 718 discs were machined for prolonged periods at several cutting speeds, feed-rates and depth of cut. Tests were interrupted to measure ...
Heat transferred to the workpiece based on temperature measurements by IR technique in dry and lubricated drilling of Inconel 718
(Elsevier, 2016)
In manufacturing aeronautical critical components, such as turbine discs commonly made of Inconel 718, surface integrity is crucial to ensure their fatigue life. Among the machining processes used, the drilling operation ...
New Calibration method to measure Rake Face Temperature of the tool during Dry Orthogonal Cutting using Thermography
(Elsevier Ltd., 2018)
A new method for measuring temperature in the rake face of a tool during dry orthogonal cutting using ther-
mography is presented. In addition, a new technique is also used to calibrate the infrared camera. Using ...
Effect of heat Treatment Conditions on the Machinability of Ti64 and Ti54 M Alloys
(Elsevier, 2012)
Orthogonal tests on cylindrical workpieces were carried out to analyze the effect of heat treatment on the machinability of newly developed Ti54M titanium alloy in comparison with Ti64. This paper focuses on the comparison ...
Surface Integrity Analysis when Machining Inconel 718 with Conventional and Cryogenic Cooling
(Elsevier, 2016)
Cryogenic machining together with minimum quantity lubrication (MQL), is claimed to be a promising alternative to flood cooling in industrial applications since it avoids the use of large amounts of cutting fluids and it ...
Enhancing surface integrity of A7050-T7451 aluminium alloy by pneumatic machine hammer peening
(Elsevier Ltd., 2022)
Aerostructures withstand cyclic mechanical loads and therefore, their design must fulfil surface integrity and fatigue strength requirements. This paper studies the effect of pneumatic machine hammer peening on surface ...
Uncertainty of Temperature Measurements in Dry Orthogonal Cutting of Titanium Alloys
(Elsevier, 2015)
Infrared radiation thermometer is used to measure the temperature of tool during dry orthogonal cutting of titanium alloys. The accuracy of measured temperature depends on several parameters such as the experimental set-up, ...
Finding correlations between tool life and fundamental dry cutting tests in finishing turning of steel
(Elsevier, 2015)
Tool life is usually measured by end tool life tests, however, such experiments are costly and time consuming. Establishing correlation between these tests and shorter and cheaper tests is consequently of great interest. ...
Machining behaviour of Ti-6Al-4V and Ti-5553 alloys in interrupted cutting with PVD coated cemented carbide
(Elsevier, 2012)
Machining behaviour of Ti-5553, Ti-6Al-4 V mill-annealed (MA) and Ti-6Al-4 V solution treated and aged (STA) alloys was studied in different interrupted cutting operations using PVD coated cemented carbide tools. Single ...