Buscar
Mostrando ítems 81-90 de 178
Analysis and Evaluation of a Wired/Wireless Hybrid Architecture for Distributed Control Systems With Mobility Requirements
(IEEE, 2019)
Wireless communications offer significant benefits over wired communications, which has increased their popularity in industrial applications. Nevertheless, the existing wireless standard technologies do not satisfy the ...
Fully pipelined implementation of tree-search algorithms for vector precoding
(Hindawi, 2013)
The nonlinear vector precoding (VP) technique has been proven to achieve close-to-capacity performance in multiuser multipleinput multiple-output (MIMO) downlink channels. The performance benefit with respect to its linear ...
Definición de una metodología optimizada para la simulación del desgaste en materialesOptimized methodology for the wear simulation of metallic materials
(Consejo Superior de Investigaciones Científicas (CSIC), 2010)
The wear simulation with finite element method (FEM) presents great advantages for the improvement of components, because of the reduction in the cost in comparison to the experimental procedure (test time, materials, ...
Finite element modeling of fretting wear scars in the thin steel wires : Application in crossed cylinder arrangements
(Elsevier Ltd, 2014)
This paper completes a series of two papers in which a FE based methodology for the prediction wear scars in thin steel wires under fretting wear conditions is developed. In the first paper ‘Finite element modeling and ...
Uncertainty of Temperature Measurements in Dry Orthogonal Cutting of Titanium Alloys
(Elsevier, 2015)
Infrared radiation thermometer is used to measure the temperature of tool during dry orthogonal cutting of titanium alloys. The accuracy of measured temperature depends on several parameters such as the experimental set-up, ...
Experimental and FEM analysis of surface integrity when broaching Ti64
(Elsevier, 2018)
The performance of aeronautic critical components is strongly dependent on its fatigue behavior, which is directly linked to their surface integrity condition. Broaching operation is a machining operation extensively used ...
Reduction of distortions in large aluminium parts by controlling machining-induced residual stresses
(Springer, 2018)
Large aluminium monolithic parts used in the aeronautic industry frequently show significant geometric distortions after the machining process. These distortions are the consequence of the initial residual stresses of the ...
Effect of cutting speed on the surface integrity of face milled 7050-T7451 aluminium workpieces
(Elsevier Ltd., 2018)
The guarantee of surface integrity has become a primary objective for researchers when analysing the reliability of machined aircraft aluminium alloy structural parts in high-speed machining. This work studies the effect ...
The CEL Method as an Alternative to the Current Modelling Approaches for Ti6Al4V Orthogonal Cutting Simulation
(Elsevier B.V., 2017)
The finite element approach is often adopted to study the machining process. The Lagrangian and Eulerian formulations or even Arbitrary Eulerian-Lagrangian (ALE), one of their combinations, are the most employed in the ...
Hardware-in-the-loop performance analysis of a railway traction system under sensor faults
(IET, 2019)
Fault mode and effects analysis (FMEA) has been used during decades for analysing the effects of faults in different applications. Initially, FMEA based on risk priority numbers provided information about the effects in ...