Search
Now showing items 11-13 of 13
Sensitivity analysis of the input parameters of a physical based ductile failure model of Ti-6Al-4V for the prediction of surface integrity
(Elsevier Ltd, 2020)
In machining of Ti-6Al-4V, it is commonly reported the appearance of segmented chip produced by adiabatic shearing (at high cutting speeds) and lack of ductility (at low cutting speeds). Moreover, machining is a manufacturing ...
Reduction of distortions in large aluminium parts by controlling machining-induced residual stresses
(Springer, 2018)
Large aluminium monolithic parts used in the aeronautic industry frequently show significant geometric distortions after the machining process. These distortions are the consequence of the initial residual stresses of the ...
Correcting distortions of thin-walled machined parts by machine hammer peening
(Elsevier, 2023)
Thin-walled aerostructural components frequently get distorted after the machining process. Reworking to correct distortions or eventually rejecting parts significantly increases the cost. This paper proposes a new approach ...