Buscar
Mostrando ítems 521-530 de 766
Procedure to predict residual stress pattern in spray transfer multipass welding
(Springer, 2015)
Gas metal arc welding (GMAW) is one of the most used joining method in the industry. However, one of the main problems of this process is the generation of residual stresses which have direct impact on the fatigue life of ...
Digital Interferometry Applied to Thermogravitational Technique
(Springer, 2018)
In this work, we have applied Optical Digital Interferometry approach to thermogravitational micro-column technique. By the new analysis, we examine the entire height of the micro-column and determine the complete concentration ...
Thermodiffusion Coefficients of Water/Ethanol Mixtures for Low Water Mass Fractions
(Springer, 2016)
The difficulty of measuring the thermodiffusion coefficients by optical properties of water-ethanol binary mixtures of approximately 20 wt % of water has been highlighted by several authors in recent years. This is because ...
A Note on Interpreting Tool Temperature Measurements from Thermography
(Taylor & Francis, 2015)
Thermography (thermal imaging) is a well-established experimental method for studying cutting tool temperature distributions. In one form, cutting edge temperatures within the chip / tool contact area are deduced from ...
Sensitivity analysis of the input parameters of a physical based ductile failure model of Ti-6Al-4V for the prediction of surface integrity
(Elsevier Ltd, 2020)
In machining of Ti-6Al-4V, it is commonly reported the appearance of segmented chip produced by adiabatic shearing (at high cutting speeds) and lack of ductility (at low cutting speeds). Moreover, machining is a manufacturing ...
Influence of lubrication condition on the surface integrity induced during drag finishing
(Elsevier Ltd, 2020)
Tribofinishing is one of the most popular polishing process in industry. The action of small abrasive media around parts enables to reduce significantly surface roughness and at the same time, to induce compressive residual ...
Surface drag analysis after Ti-6Al-4V orthogonal cutting using grid distortion
(Elsevier Ltd, 2020)
Surface integrity directly affects the mechanical behavior of the workpiece, which is especially relevant on fatigue behavior. To characterize the quality of the machined surface, aspects such as material damage, roughness ...
Determining tool/chip temperatures from thermography measurements in metal cutting
(Elsevier, 2018)
Temperature measurement in metal cutting is of central importance as tool wear and surface integrity have been demonstrated to be temperature dependent. In this context, infrared thermography is presented as a reliable ...
Comparative small-signal evaluation of advanced grid-forming control techniques
(Elsevier B.V., 2022)
This paper presents the small-signal modelling and analysis of the most recent grid-forming control techniques, namely the matching control (MC) and the dispatchable virtual oscillator (dVOC). These are compared to more ...
Reduction of distortions in large aluminium parts by controlling machining-induced residual stresses
(Springer, 2018)
Large aluminium monolithic parts used in the aeronautic industry frequently show significant geometric distortions after the machining process. These distortions are the consequence of the initial residual stresses of the ...