Now showing items 1-7 of 7
Experimental and FEM analysis of surface integrity when broaching Ti64
The performance of aeronautic critical components is strongly dependent on its fatigue behavior, which is directly linked to their surface integrity condition. Broaching operation is a machining operation extensively used ...
A Coupled Eulerian Lagrangian Model to Predict Fundamental Process Variables and Wear Rate on Ferrite-pearlite Steels
(Elsevier B.V., 2017)
A coupled Eulerian-Lagrangian Finite Element model of the orthogonal cutting process was developed to predict the influence that ferritepearlite steel variants have on fundamental process variables and tool wear. As a case ...
The CEL Method as an Alternative to the Current Modelling Approaches for Ti6Al4V Orthogonal Cutting Simulation
(Elsevier B.V., 2017)
The finite element approach is often adopted to study the machining process. The Lagrangian and Eulerian formulations or even Arbitrary Eulerian-Lagrangian (ALE), one of their combinations, are the most employed in the ...
FEM modeling of hard turning 42CrMoS4 steel
(Elsevier B.V., 2019)
Numerical characterization of local and global non-uniformities in the load distribution in ball screws
Load distribution in ball screws is a representation of the ball contact stress, and it is fundamental to understanding the behavior of these machine elements. This work aims to conduct a multi-variable analysis of the ...
Analytical Model to Calculate Radial Forces in Permanent-Magnet Synchronous Machines
There are three principal sources of noise and vibration in electrical machines: electromagnetic sources, mechanical sources, and aerodynamic sources. Nowadays, one of the major advantages of permanent-magnet synchronous ...
Sensitivity analysis of the input parameters of a physical based ductile failure model of Ti-6Al-4V for the prediction of surface integrity
(Elsevier Ltd, 2020)
In machining of Ti-6Al-4V, it is commonly reported the appearance of segmented chip produced by adiabatic shearing (at high cutting speeds) and lack of ductility (at low cutting speeds). Moreover, machining is a manufacturing ...