Bilatu
37-tik 11-20 emaitza erakusten
Design of a Radiant Heat Capturing Device for Steel Mills
(International Centre for Sustainable Development of Energy, Water and Environment Systems, 2021)
This paper approaches the energy transition towards decarbonization and lower primary energy use in the steel and glass industries through the exploitation of radiant waste heat. In contrast with exhaust gases heat recovery, ...
Steady-state Measurements of Ternary Mixtures in Thermogravitational Microcolumn Using Optical Digital Interferometry
(Springer Nature B.V., 2021)
Steady-state measurements in a thermogravitational microcolumn using optical digital interferometry are presented here for the first time in the literature in the case of ternary mixtures. These measurements enabled the ...
Thermodiffusion in Ternary Mixtures of Water/Ethanol/Triethylene Glycol: First Report on the DCMIX3-Experiments Performed on the International Space Station
(Springer, 2018)
We report on thermodiffusion experiments conducted on the International Space Station ISS during fall 2016. These experiments are part of the DCMIX (Diffusion and thermodiffusion Coefficients Measurements in ternary Mixtures) ...
Sorption isotherm, glass transition, and diffusion coefficient of polyacrylamide/water solutions
(ACS Publications, 2012)
The sorption isotherm, the glass transition, and the mutual diffusion coefficient of polyacrylamide/water solutions are obtained experimentally. All of these parameters are measured in the concentrated regime by gravimetric ...
Determination of molecular diffusion coefficient in n-Alkane binary mixtures: empirical correlations
(ACS Publishing, 2012)
In this work we have measured the molecular diffusion coefficient of the n-alkane binary series nCi-nC6, nCi-nC10, and nCi-nC12 at 298 K and 1 atm and a mass fraction of 0.5 by using the so-called sliding symmetric tubes ...
Design and 3D printing of an electrochemical sensor for Listeria monocytogenes detection based on loop mediated isothermal amplification
(Elsevier, 2023)
The aim of this work is the design and 3D printing of a new electrochemical sensor for the detection of Listeria monocytogenes based on loop mediated isothermal amplification (LAMP). The food related diseases involve a ...
High magnetization FeCo nanoparticles for magnetorheological fluids with enhanced response
(Royal Society of Chemistry, 2021)
We present results concerning the fabrication of a new magnetorheological fluid with FeCo magnetic nanoparticles (NPs) as magnetic fillers. These NPs have been fabricated by using the chemical reduction technique and show ...
Influence of the test-chamber shape on the performance of conductometric gas sensors
(Elsevier, 2022)
In this article, CFD simulations results are presented as a key tool to the comprehension of the target gas concentration evolution in a test chamber, at different working conditions. The simulation results are compared ...
Mass effect on the soret coefficient in n-alkane mixtures
(AIP Publishing, 2014)
We have determined the Soret coefficient of different equimolar and non equimolar n-alkane mixtures from measurements of the molecular diffusion and thermal diffusion coefficients. It is shown that equimolar mixtures behave ...
Analysis of thermophoresis for separation of polystyrene microparticles in microfluidic devices
(Elsevier, 2022)
We analysed the thermodiffusion phenomenon both numerically and experimentally for size-based separation of polystyrene microparticles. For model validation, we followed previously published numerical studies using ANSYS ...