Bilatu
18-tik 11-18 emaitza erakusten
Reduction of distortions in large aluminium parts by controlling machining-induced residual stresses
(Springer, 2018)
Large aluminium monolithic parts used in the aeronautic industry frequently show significant geometric distortions after the machining process. These distortions are the consequence of the initial residual stresses of the ...
Mechanical and electrical properties of additively manufactured copper
(IOP Publishing, 2021)
Additive Manufacturing (AM) has become the new paradigm of design and production strategies. While structural and functional materials are the most implemented ones, it is also possible to manufacture parts using precious ...
Surface topography irregularities generated by broaching
(Elsevier Ltd., 2022)
Surface topography irregularities generated by broaching are analysed. Experimental tests were carried out on three workpiece materials: AISI 1045, Ti-6Al-4V, and Inconel 718, varying the cutting speed, rise per tooth, and ...
Influences of Cutting Speed and Material Constitutive Models on Chip Formation and their Effects on the Results of Ti6Al4V Orthogonal Cutting Simulation
(2021)
The highly used Ti6Al4V alloy is a well know hard-to-machine material. The modelling of orthogonal cutting process of Ti6Al4V attract the interest of many researchers as it often generates serrated chips. The purpose of ...
Sensitivity analysis of the input parameters of a physical based ductile failure model of Ti-6Al-4V for the prediction of surface integrity
(Elsevier Ltd, 2020)
In machining of Ti-6Al-4V, it is commonly reported the appearance of segmented chip produced by adiabatic shearing (at high cutting speeds) and lack of ductility (at low cutting speeds). Moreover, machining is a manufacturing ...
Microstructural aspects of the transition between two regimes in orthogonal cutting of AISI 1045 steel
(Elsevier, 2018)
In depth understanding of tool-chip friction behavior is a significant aspect for tool wear performance in steels. In the present work attention has been paid to the strain mode of the chip section in contact with the rake ...
Effect of surface integrity generated by machining on isothermal low cycle fatigue performance of Inconel 718
(Elsevier Ltd., 2022)
Critical aero-engine components such as turbine discs must withstand severe cyclic stresses, which can eventually lead to low cycle fatigue (LCF) failures. These components are made of difficult-to-cut alloys and machining ...
Optimal manufacturing configuration selection: sequential decision making and optimization using reinforcement learning
(Elsevier, 2023)
In manufacturing, different costs must be considered when selecting the optimal manufacturing configuration. Costs include manufacturing costs, material costs, labor costs, and overhead costs. Optimal manufacturing ...