Bilatu
16-tik 11-16 emaitza erakusten
Enhancing surface integrity of A7050-T7451 aluminium alloy by pneumatic machine hammer peening
(Elsevier Ltd., 2022)
Aerostructures withstand cyclic mechanical loads and therefore, their design must fulfil surface integrity and fatigue strength requirements. This paper studies the effect of pneumatic machine hammer peening on surface ...
Sensitivity analysis of the input parameters of a physical based ductile failure model of Ti-6Al-4V for the prediction of surface integrity
(Elsevier Ltd, 2020)
In machining of Ti-6Al-4V, it is commonly reported the appearance of segmented chip produced by adiabatic shearing (at high cutting speeds) and lack of ductility (at low cutting speeds). Moreover, machining is a manufacturing ...
Evaluation of different flow stress laws coupled with a physical based ductile failure criterion for the modelling of the chip formation process of Ti-6Al-4V under broaching conditions
(Elsevier, 2019)
During the machining of Ti-6Al-4V the changing deformation mechanisms produce a complex microstructure of segmented chips, which directly influenced tool-wear and process stability. Numerical simulation could give an insight ...
Force Prediction Methodology for Complex Shape Broaching
(Elsevier B.V., 2023)
Broaching is widely used for the manufacturing of complex geometries which requires high dimensional accuracy and surface finishing (e.g., fir tree, dovetail). A software development for force prediction in complex shape ...
Effect of Tool Geometry and LCO2 Cooling on Cutting Forces and Delamination when Drilling CFRP Composites Using PCD Tools
(Elsevier, 2022)
Lightweight materials like Carbon Fiber Reinforced Polymers (CFRPs) present certain challenges, mainly regarding the resultant surface integrity of the holes. Different techniques such as optimized tool geometries, machining ...
Correcting distortions of thin-walled machined parts by machine hammer peening
(Elsevier, 2023)
Thin-walled aerostructural components frequently get distorted after the machining process. Reworking to correct distortions or eventually rejecting parts significantly increases the cost. This paper proposes a new approach ...