Listar por tema "Wear"
Mostrando ítems 1-9 de 9
-
A Coupled Eulerian Lagrangian Model to Predict Fundamental Process Variables and Wear Rate on Ferrite-pearlite Steels
(Elsevier B.V., 2017)A coupled Eulerian-Lagrangian Finite Element model of the orthogonal cutting process was developed to predict the influence that ferritepearlite steel variants have on fundamental process variables and tool wear. As a case ... -
An all-in-one numerical methodology for fretting wear and fatigue life assessment
(Gruppo Italiano Frattura, 2016)Many mechanical components such as, bearing housings, flexible couplings and spines or orthopedic devices are simultaneously subjected to a fretting wear and fatigue damage. For this reason, the combined study on a single ... -
Ball-on-flat linear reciprocating tests: Critical assessment of wear volume determination methods and suggested improvements for ASTM D7755 standard
(Elsevier B.V., 2021)This work presents a critical assessment of wear volume determination methods for ball-on-flat linear reciprocating sliding tribological tests. It revealed that the ASTM D7755-11 standard leads to the highest relative ... -
Definición de una metodología optimizada para la simulación del desgaste en materiales
(Consejo Superior de Investigaciones Científicas (CSIC), 2010)The wear simulation with finite element method (FEM) presents great advantages for the improvement of components, because of the reduction in the cost in comparison to the experimental procedure (test time, materials, ... -
Influence of tool wear on residual stresses when turning Inconel 718
(Elsevier, 2016)This paper analyzes the effect of tool wear on residual stresses when turning. Inconel 718 discs were machined for prolonged periods at several cutting speeds, feed-rates and depth of cut. Tests were interrupted to measure ... -
On the Role of a ZDDP in the Tribological Performance of Femtosecond Laser-Induced Periodic Surface Structures on Titanium Alloy against Different Counterbody Materials
(MDPI, 2019)Laser-induced periodic surface structures (LIPSS, ripples) with ~500–700 nm period were produced on titanium alloy (Ti6Al4V) surfaces upon scan processing in air by a Ti:sapphire femtosecond laser. The tribological ... -
Optimising Maintenance: What are the expectations for Cyber Physical Systems
(IEEE, 2016)The need for maintenance is based on the wear of components of machinery. If this need can be defined reliably beforehand so that no unpredicted failures take place then the maintenance actions can be carried out economically ... -
A review of the effects of cyclic contact loading on fretting fatigue behaviour
(Sage Publishing Ltd., 2020)A damage phenomenon called fretting fatigue frequently takes place when two contact bodies are clamped together under a normal contact load along with a small-scale oscillatory motion due to cyclic loading. In contrast to ... -
Tool Damage and Adhesion Effects in Turning and Drilling of Hardened Steels
(World Academy of Science, 2016)Noteworthy results have been obtained in the turning and drilling of hardened high-strength steels using tungsten carbide based cutting tools. In a finish turning process, it was seen that surface roughness and tool flank ...
